FoxInCloud
PCOUNT after Adapt
06/19/2012
09:36:32 AM
3J30KLIPI![Show this entire thread in new window]()
09:36:32 AM
3J30KLIPI
From:
Patrick
To:
All
Attachments:
None
I adapted a form and in the init this is what FIC did. The This.Get_data() no longer runs if no parameter is sent. I can move this line outside the Pcount IF/ENDIF to fix. Thought I would put this out there in case this is not by design.
LPARAMETERS iEmp IF Pcount() > 0 && Added by FoxInCloud Adaptation Assistant version 1.25 (source mode) on 06/19/2012 09:00:32 AM DoDefault() && Added by FoxInCloud Adaptation Assistant version 1.25 (source mode) on 06/19/2012 09:00:32 AM IF PCOUNT() > 0 vEMp_id = (m.iEMP) thisForm.wViewParmSet('employee_id',"vEMP_ID",m.vEMp_id,.T.) thisform.refresh() ENDIF This.Get_data() ENDIF && Added by FoxInCloud Adaptation Assistant version 1.25 (source mode) on 06/19/2012 09:00:32 AM